16.
Installing the sewer connection/saddle connector
17.
It is recommended to install the sewer connection/drainpipe connection in the sewer pipe before the
drain hose and the water trap (the drain pipe connection is suitable for all sewer pipes with an internal
diameter of 40 mm).
18.
The drainpipe begins from the non-return valve (Flow 420).
19.
Remove the protective film from the seal. Glue the tape seal to the inside of the connection. The hole
in the seal should match the hole in the drain connection.
20.
Attach the connector to the drainpipe and tighten the screws. The screws must be tightened evenly
so that the two parts of the connection remain at the same level.
21.
Drill a 7 mm hole through the connection pipe of the connection.
22.
Insert the plastic nut into the JG pipe (black), insert the pipe into the connection and tighten the nut.
Attention! Make sure that the connection pipe is deep enough, but not attached to the back wall of the
drainpipe and that it is firmly attached to the drain connection in order to avoid noise and other nuisances.
23.
Installing the supply water connection (branch) and shut-off valve
24.
It is recommended to install the supply water connection behind the shut-off valve, for example
between the dishwasher connection, if the dishwasher is used and connected to a cold water line.
Another option is the installation on the cold water line as shown.
Cold water line
1/2 ”splitter
1/2 ”splitter
Shut-off valve
PTFE/Teflon tape