
11.
Installing a clean water tap
12.
Drill a 12 mm hole in the basin (table). Note that there should be enough space under the level for
the finger nut and for tightening it.
13.
Install the faucet components in the order shown in the picture.
14.
Tighten the hose connector by hand and make the final tightening with a tool. Note that the
connector is made of plastic, so excessive tightening may break it. There is an o-ring seal between the
connector, which doesn’t require much force to tighten.
15.
Connect the hose to the hose connector.
Hose connector
Finger Nut
Rubber seal
Table top
O-ring seal