Aquila ATO1, Руководство по обслуживанию

Страница: 35 / 198

MAINTENANCE MANUAL
AQUILA AT01
Aviation by Excellence AG
Check tire pressure and proper location of the red slide marks.
4. Nose Gear Strut Mount - Check for deformation, cracks, X
and corrosion. Check nose gear strut journal bearing for
proper operation, play and correct safetying.
5. Nose Gear Strut and Elastomer Package - Check strut for X
deformation, stress marks, and cracks. Inspect correct
installation of the nose wheel fork. Inspect elastomer package
for wear, deterioration, cracks, correct fit and security.
Check journal bearings of the elastomer package for play and
condition.
6. Nose Wheel Steering - Inspect nose wheel steering tubes for X
condition, excessive play and correct safetying. Check return
springs at nose gear strut for security and verify they
tension-free, if the nose wheel is in neutral position.
7. Main Landing Gear - Check main gear struts for deformation, X
cracks, damage to the paint coat, and corrosion. Inspect
wheel axles for security of attachment to struts and for any
damage.
8. Wheel Bearings - Clean and lubricate. 12-22-00 X
9. Wheel Brakes - Clean. Check freedom of movement of the 32-40-00 X
pistons and pressure plates. Inspect brake disks and brake
linings for condition and wear. Replace brake disk if worn
below 3,8 mm (0.15 in.). Replace brake linings when worn to
3,0 mm (0.12 in.). Inspect brake fluid carrying lines at the
main landing gear for condition, leakage, and security of
attachment.
Page 13
05-20-00
Maintenance Checks
No. Reference Interval Initials
100 h Add.
Nose and Main Landing Gear (Cont.)
No. Reference Interval Initials
100 h Add.
Return to Service
1. Install wheel fairings. X
Install seats.
Install cabin floor boards.
Install baggage compartment floorboard.
Install access panel of the baggage compartment bulkhead.
Install access panel 310AB.
06-30-00
2. Flight Controls - Check for full range of travel and excessive X
friction.
3. Flaps - Operate through full extension and retraction for X
steady and complete deployment. Check correct limit
switches operation at CRUISE, T/O and LDG flap positions.
Verify the corresponding flap switch position and the
corresponding flap position indicator reading.
4. Elevator Trim - Check for full range of travel and excessive X
friction. Inspect proper operation of the trim control switch,
30.04.08