23
G Door Seal & Restraint:
1. Door Seal to Front Panel Fixing
The door seal is fixed to the cabinet front panel by a wire clamp and a small spring. The spring is
normally at the bottom of the door.
Carefully place a small screwdriver into one of the lugs of the spring and by stretching the spring
the wire band can be removed.
2. Drum Fixing
The door seal is fixed to the drum with a zipper retainer. After removing the front panel (J),
remove the zipper as shown in Fig. 3 below.
On refitting place the strap around the door seal and tighten as shown in Fig. 4. Observe correct
seal and zipper fixing positions as shown in Fig. 5 and Fig. 6.
H Door Interlock
1. Remove the door seal restraint (G).
2. Peel the door seal off the front panel, and fold it back into the inner drum.
3. Remove two screws from the interlock.
4. The interlock can now be eased out, allowing access to the wiring connection block.
5. Care must be taken to ensure the correct orientation of the wiring connection plug to prevent
seriously damaging the interlock and / or control board.
Seal to Drum fixing position
Correct Seal position at Drum Front
Fig. 3
Fig. 4
Plastic Support
(observe position)
Zipper
Fig. 5
Fig. 6
Fig. 6
Alignment guide
