22
DISMANTLING INSTRUCTIONS
SAFETY NOTES
1. Ensure that the appliance is disconnected from the electrical supply before dismantling.
2. Beware of sharp edges on metal panels, plastic mouldings, and pressed parts.
3. Some fixings (especially those into plastic) must be tightened to the correct specification using a
suitable torque wrench.
4. Insulation resistance tests must be carried out with the pressure switch set to ensure that the
water heater is 'in-circuit' during the test.
A Table Top
1. Remove the two screws at the top rear of cabinet.
2. Slide the table top backwards to disengage the location fixings and lift off.
B Lower Rear Access Panel
1. Remove 2 screws from the lower rear access panel.
2. Pull the top edge of the panel out and disengage it from its location fixings along the bottom.
C Dispenser Drawer
1. Open the dispenser drawer fully.
2. Press release latch in centre of drawer and pull drawer body and pull drawer away from console.
D Console Panel
1. Remove the table top (A) and dispenser drawer (C).
2. Remove two top screws securing console to cabinet and two screws securing console to
dispenser.
3. Unplug wiring from console PCB - taking note of position.
4. Slide dispenser back.
5. Unclip two plastic lugs securing console panel to front panel and lift clear.
6. Avoid unclipping and handling the control board unless absolutely necessary, as the control
board is susceptible to static electricity.
E Console PCB and Button Assemblies
1. Remove the console panel (D).
2. Remove wiring plug - taking note of position.
3. Remove three securing clips and lift away from the console.
F
Pressure Switch
1. Remove the table top (A).
2. Disconnect the wiring connection block and pressure hose.
3. Carefully rotate the pressure switch in a clockwise direction to release from the cabinet.
