8
•
Inspect all bilges and pump-out if necessary
•
Check the general condition of the BELTS, HOSES, and FUEL LINES.
•
Ensure the valve on each RAW WATER THRU-HULL is in the
‘open’
position (lever in- line
with valve). Periodically check the raw water strainers: close the seacock, open the strainer
cover, clean the strainer, and reassemble. Remember to reopen the seacock. Check your
generator fluids as well.
Start-Up
•
Before starting the engine, do your inspection. The engine should be started from the lower helm
station. A full set of engine alarm indicators is located above the lower helm and on the
flybridge panel.
•
Ensure GEARSHIFT is in ‘neutral’
. BE ADVISED THAT THE ENGINE WILL START IN
FORWARD OR REVERSE GEAR. PLEASE AVOID DOING THIS AS IT IS
HARMFUL TO THE ENGINE!!
THROTTLE should be run up and down and then brought
almost back to the idle position. Insert the key into the IGNITION SWITCH.
•
Turn the key fully CLOCKWISE and the ENGINE DIAL PANEL above the helm will activate.
Press the BLACK STARTBUTON and release when you hear the engine start.
•
A prolonged engine warm-up is not necessary. Even when the engine is cold, a period 0f 2-3
minutes at 1200 RPM before engaging the engine is adequate. You can stow lines and cords
during this time.
•
Observe the readings of the engine gauges. At normal operating RPM, the oil pressure will
register approximately 40-50 PSI. The engine temperature should rise slowly. Normal
operating temperature is approximately 175 degrees Fahrenheit. At idle, engine should register
~700 RPM.
Filters
John Deere Main Engine
Oil- RE541420
Racor Fuel – 900 2 micron
Water separator – RE 515368 30 mic
Water separator – RE62425 150 mic
Содержание AQUARIUS SELENE 40
Страница 3: ...3 ...
