14
CONTOIL
®
DFM
Error Log
This screen shows you, with data and time stamp, the last stored Error Messages in a readable form.
Press
the
arrows to go through the messages.
Config Log Entry
The DFM-BC has the ability to store all configuration changes. If the Error Log is full, the oldest entry will be deleted.
This screen shows you, when the last configuration change was recorded.
Press OK to enter the Config Log.
Config Log
This screen shows you, with data and time stamp, the last stored configuration change in a readable way.
Press
the
arrows to go through the messages.
Clock
This screen shows you the date and time.
Factory Data
This screen shows you the firmware version and the serial number of the DFM-BC,
which can/will change over the time.
For Service People ... parameter setting (Service Mode)
In this section we assume that the service engineer is familiar with the differential measurement technique and also knows the previous
sections. In the Service Mode mode you have unrestricted access to all vital parameter. Please be careful in changing parameter.
Inadequate parameter settings can lead to incorrect function and calculations.
A good way to avoid mistakes is to write down the parameters before you change it.
1.
From
the
User Mode go with the
arrow or
arrow to the Service screen and press OK. After you entered
the
Service
mode,
the
2.
ESC key
a.
brings
you
back
one step or
b.
brings
you
back
one digit
(one
position).
