Aquacal SunPower SP05, Руководство по установке

Страница: 39 / 108

Page - 35
1.6.g Site Configuration Presets (Optional)
A list of site configurations (presets) can be used to easily configure equipment directly connected to the
heat pump. Connected equipment, such as a circulation pump for example, can have all the necessary
options automatically set to operate the device.
NOTICE
Failure to heed the following may result in damage to equipment.
l
Any existing programs or settings will be cleared and replaced with the chosen preset option. If this is undesired,
then press the button under "SKIP" to exit the wizard and set up equipment manually.
l
After using a preset, values such as system RPMs should be checked to confirm they do not exceed system
requirements. Damage to equipment due to excessive water flow, from setting RPMs too high, is not covered
under factory warranties.
NOTE
After using a preset, any setting can be manually customized (or fine tuned) by the
installer. Values, such as circulation pump RPMs, should be checked to confirm they do
not exceed system requirements.
ALSO NOTE
l
If necessary, the system can be set to factory default if an incorrect preset has been used. See
"
Factory Reset " on page 68.
l
If a third-party external controller was used prior to upgrading the system, a factory reset
will be required to see all presets. See "
Factory Reset " on page 68.
l
If the PoolSync
®
external controller was used prior to upgrading the system, all applicable
heat pump presets will be shown.
Navigate to the installation menus to access these preset configurations.
A
PRESS MENU
BUTTON
B
USE ARROWS TO
"SYSTEM"
C
PRESS "ENTER"
D
USE ARROWS TO
"ADVANCED"
E
PRESS "ENTER"
F
USE ARROWS TO
"INSTALLATION"
G
PRESS "ENTER"
The first set of menus offered will be the site configuration presets.
1
-
Ins
ta
lla
tion