Aquacal SunPower SP05, Руководство по установке

Страница: 71 / 108

Page - 67
2.5 Equipment Parameters
This section describes all the possible parameters for equipment that can be connected to the heat pump.
Pumps
Parameter Description
Name
A set of labels is provided for easy identification of the circulation
pump.
Pump Type
A choice between a variable speed or single speed circulation
pump is provided.
Port
This is the connection port where a circlulation pump is connected
to the heat pump.
l
The connection ports are normally "Port B" on the control board for
a variable speed circulation pumps.
l
And expansion board ports "A" (default), "C", and / or "D" for
single speed or multi-speed circulation pumps.
Minimum Speed The minimum allowed speed for the circulation pump to operate.
Maximum Speed The maximum allowed speed for the circulation pump to operate.
Priming Time
The amount of time allowed to prime the variable speed circulation
pump to remove air bubbles in the lines. Air bubbles would prevent
the water from circulating properly in the system.
Priming Speed
The variable speed circulation pump's operating speed when
priming the equipment.
Heat / Cool Speed
The speed a variable speed circulation pump must run when
actively heating or cooling the water.
Actuators
Parameter Description
Name
A set of labels are provided for easy identification of the circulation
pump's valve actuator.
Valve Type
Currently there is only one choice for this option. (24 VAC
STANDARD).
Port
This is the connection port where the device is connected to the heat
pump's expansion board.
Off Position
Name
The name of the position that signifies the actuator is inactive.
On Position
Name
The name of the position that signifies the actuator is active.
2
-
A
ppe
ndi
x