Aquacal HeatWave SuperQuiet SQ120R, Руководство по установке

Страница: 30 / 145

Page - 26
ChlorSync Power Connection to Heat Pump
1. Deactivate power to heat pump.
2. Route the ChlorSync cell cord so that it is protected from
possible damage by lawn equipment or foot traffic. If
desired, the cord may be secured to plumbing or electrical
conduit using tie wraps (not included).
3. Align and insert the six (6) pin cell cord connector to the heat
pump's power supply port as indicated.
4. Turn the round nut until it locks the connector in place.
5. Apply power to heat pump.
ChlorSync Connectioned to Heat Pump
1.6.c Connecting External Controllers to Heat Pump
To support a direct connection to an external controller, AquaCal ® heat pumps are equipped with optional
removable terminal blocks on the microprocessor. The microprocessor is located on the low-voltage side of
the electrical enclosure.
DANGER
Failure to heed the following will result in injury or death.
l
RISK OF ELECTRICAL SHOCK FROM ENERGY STORED IN CAPACITORS - MODELS EQUIPPED
WITH VARIABLE FREQUENCY COMPRESSOR DRIVES STORE ELECTRICITY EVEN AFTER THE
POWER HAS BEEN DEACTIVATED AT THE POWER BREAKER.
Wait for 2 minutes after the shut down
of equipment before servicing.
l
Deactivate power while routing wiring to control board.
l
Follow all National Electric Codes (NEC) and/or State and Local guidelines.
1
-
Ins
ta
ll
at
ion