Page - 7
1.4 Plumbing
1.4.a Plumbing Requirements
NOTICE
Failure to heed the following may result in damage to equipment.
l
Do not use glue on the threaded portion of the equipment’s unions. A glued-in-place union will prevent the
equipment from being properly winterized.
l
The heat pump must receive water flow within the specified minimum ranges under worst-case conditions such as
a fouled water filter.
l
Failure to provide clean filtered water to the heat pump can void the product warranty.
l
Water flow exceeding maximum flow rates will negatively affect the total pool filtration performance and may
damage the heat pump. This will not be covered under the equipment warranty.
l
Install a bypass valve whenever water-flow may exceed the maximum rating.
l
l
For additional guidance testing water flow rates, please contact AquaCal
®
.
l
A safety-enhancing "Over Temperature Alarm" kit is strongly recommended for all spa applications.
1.4.b Plumbing Diagrams
Plumbing diagrams are provided in this section as a planning guide to the sequence of equipment, valves, and
fittings.
l
The basic plumbing configurations for typical installations are shown.
l
If the installation does not closely follow any of the supplied plumbing diagrams, AquaCal
®
Technical Support is
available for installation advice and guidance.
l
Confirm water provided to the heat pump is clean and filtered.
Heat Pump with water flows equal or less than the maximum listed flow rate
1
-
Ins
ta
lla
tion
Содержание HeatWave SuperQuiet SQ120R
