Aquacal HeatWave SuperQuiet SQ120R, Руководство по установке

Страница: 16 / 145

Page - 12
MODEL HEAT EXCHANGER TYPE
FLOW RATES
MINIMUM MAXIMUM
T055 Titanium Tube-in-Tube 20 GPM (75.7 L/min) 45 GPM (170 L/min)
T075 Titanium Tube-in-Tube 20 GPM (75.7 L/min) 45 GPM (170 L/min)
T090 Titanium ThermoLink
®
30 GPM (113.6 L/min) 70 GPM (265 L/min)
T115 Titanium ThermoLink
®
30 GPM (113.6 L/min) 70 GPM (265 L/min)
T135 Titanium ThermoLink
®
30 GPM (113.6 L/min) 70 GPM (265 L/min)
T170 Titanium Tube-in-Tube 30 GPM (113.6 L/min) 70 GPM (265 L/min)
TC500 Titanium Tube-in-Tube 20 GPM (75.7 L/min) 45 GPM (170 L/min)
TC1000 Titanium ThermoLink
®
30 GPM (113.6 L/min) 70 GPM (265 L/min)
TC1500 Titanium ThermoLink
®
30 GPM (113.6 L/min) 70 GPM (265 L/min)
PLEASE NOTE -
If minimum flow rates are not met, heat pump performance is reduced and performance will
suffer. Internal safety devices may deactivate the heat pump with the following errors:
l
HIGH PRESSURE FAULT
l
HP5 SYSTEM LOCKOUT
l
LOW PRESSURE FAULT
l
LP5 SYSTEM LOCKOUT
l
Operate water filtration devices per manufacturer's specifications. Dirty filters can cause a reduction of water flow
to the heat pump. An increase of 7-10 psi (48 to 69 kPa) higher than the clean filter pressure typically reduces
flow rates. This requires the filter to be cleaned or back-washed.
l
Keep baskets free of debris. A large quantity of debris in the pump and skimmer baskets can reduce water flow.
l
Check for improper valve settings. A partially closed valve after the filter, or a full-open bypass around the heat
pump, will cause insufficient water flow through the heat pump.
l
The maximum static pressure (or operating pressure) is 50 psi (345 kPa). These specifications relate to the heat
pump only.
l
Code-specified whole system turnover rates must be satisfied.
1
-
Ins
ta
ll
at
ion