Aquacal HeatWave SuperQuiet SQ120R, Руководство по установке

Страница: 22 / 145

Page - 18
Minimum and Maximum Operating Voltage
The heat pump must operate within specified voltages.
NOTICE
Failure to heed the following may result in damage to equipment.
l
Operating equipment under higher or lower voltage conditions may result in damage to your compressor, motors
or other electrical components. This damage will not be covered by the product warranty.
1. Measure site voltage. The site voltage MUST be measured under “FULL LOAD” conditions. Activate all
equipment using the same electrical panel as the heat pump.
2. If measured site voltage is outside listed ranges, immediately deactivate equipment until site conditions have been
corrected. If unsure of heat pump equipment rating, please
see " Identifying Model Specifications " on page 79.
Equipment Rating
Minimum
Site Voltage
Maximum
Site Voltage
A Voltage
(208 to 230 Volts)
Single Phase 60 hertz
200 Volts 253 Volts
B Voltage
(208 to 230 Volts)
Three Phase 60 hertz
200 Volts 253 Volts
D Voltage
(380 to 420 Volts)
Three Phase 50 hertz
361 Volts 441 Volts
E Voltage
(380 Volts)
Three Phase 60 hertz
361 Volts 399 Volts
G Voltage
(460 Volts)
Three Phase 60 hertz
437 Volts 483 Volts
H Voltage
(200 to 240 Volts)
Single Phase 50 hertz
180 Volts 264 Volts
1
-
Ins
ta
ll
at
ion