Aqua To Go AQUA Cold, Руководство пользователя

Страница: 8 / 12

Page 8 of 12
LED INDICATORS – POWER, COOLING, COLD
To turn on the cooling operation, plug in the power cord, turn on the switch at the power outlet and on the
back of the cooler.

Power light (red) stays on when the machine is plugged into the power, power point is on and rear
power switch is on.

Cooling indicator (yellow) turns on when the machines thermo electric cooling system is running and
turns off when the water reaches its factory set cooling temperature.

Cold indicator (green) turns on when the machine has finished cooling and the water in the tank is at
the factory set optimal drinking temperature. This light will turn off when the water in the tank warms
up and the cooling system starts again.
TEMPERATURE CONTROL
The thermostat is set to deliver water generally in the range 9

C to 12

C for cold water in a non humid room
which is no greater than 25

C. Unit must be placed away from direct sunlight and any heater.
Water temperature will depend upon usage, room temperature and when the thermo electric cooling system
last activated. Accurate temperatures are measured from the water flow and not from within the container
that the water is dispensed. Any queries please contact the AQUA TO GO Service Centre ph 1300 760 474
or service@aquatogo.com.au
ELECTRICAL CONNECTION

Plug the appliance into an exclusive, properly installed, grounded wall outlet. Do not under any
circumstances alter this power plug.

This appliance requires a standard 220-240-volt, 50Hz electrical outlet with three-prong ground.

The cord should be secured behind the appliance and not left exposed or dangling as this might cause
accidental injury.

Do not use an adapter plug with this appliance.

Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician install an outlet near the appliance.
CLEANING YOUR WATER COOLER OR IF THERE’S A BAD TASTE
We suggest you give your cooler a general clean at least every 2 months or earlier if you experience a bad
taste in the water. In between general cleans we recommend that you remove and clean the spike disc and
water tank with standard dishwashing detergent.
General cleaning warning
DO NOT immerse the cooler in water. Do not hose the cooler. To prevent damage to the plastic parts, avoid
abrasive cleaning aids such as steel wool. Before cleaning always unplug the cooler from the power socket
and move to a water safe area in case you splash or water leaks. The top cover with spike, drip tray, and the
cooler plastic casing can be cleaned in warm water with any non-abrasive household cleaner, such as a mild
dishwashing liquid. Do not use bleach. Once a month inspect the plastic grill vents located on the back of the
dispenser. When turned off, remove any accumulation of dust.
To clean the stainless steel cooling tank and taps:

Unplug the water cooler from the power and turn off both power switches on the rear of the cooler.

Remove bottle and dispense all remaining water from both taps.

Move water cooler to an area outside where when water flows no damage is caused.

Unscrew the rear drain cap, which is located near the bottom of the water cooler casing. Be careful as
the water will flow out and may make a mess.

Leave the unit outside, and unplugged from the power, whilst you do the rest of the below steps.

Hold onto the spike disk, twist it anti-clockwise and lift to reveal the water tank.