Page 9 of 12
Put tap water into the tank and flush through a couple of litres through the unit, which will come out
the rear drain cap and the rest you can dispense from the taps.
Now screw back on the rear drain cap.
Mix 10ML (1/2 cap) of Milton anti-bacterial cleaning solution (available from most supermarkets)
into 1 litre of hot water and pour this into the water tank until it is full. At this time please also clean
the sides of the water tank. Now let the cooler sit over night with this cleaning solution in it.
Alternatively – Fill the tank with hot tap water and mix in two tablespoons of baking soda, leave it
overnight.
Next morning unscrew the rear drain cap and flush through at least 2 litres of tap water, dispensing
the rest of the water through the taps.
Screw the drain cap back on.
Put the water cooler back inside in the desired location and put a bottle back on the water cooler.
Very Important – Now dispense a cup of water from blue tap, before you turn power on.
Only then plug it back into the power and turn the rear power switch on.
Like all food grade dispensing products it is very important that your water cooler is always kept hygienically
clean. Should you require any further cleaning advice please visit www.aquatogo.com.au or contact our
customer service centre ph 1300 760 474 or [email protected]
STORING YOUR WATER COOLER
If the water dispenser will not be used for a long period of time:
Unplug the power cord from the electrical outlet.
Drain the water through the taps and then store away.
Note:
Only transport and store your water cooler in an upright position.
DISPOSAL OF WATER COOLER
At the end of its life this unit must be disposed of in a proper fashion. Any queries please contact your local
waste disposal centre.
TROUBLE SHOOTING GUIDE
Many common water cooler problems are easily fixed. Please read the below and if you still have an issues
please call AQUA TO GO ph 1300 760 474 or [email protected]
PROBLEM
POSSIBLE CAUSE
Water cooler does not operate.
Not plugged in or power switch off.
Power switched off at rear of the water cooler.
Power point not working.
A circuit breaker has tripped or a fuse has blown.
Water cooler is not cold enough.
The water cooler does not have the correct clearances from the
wall. Check that the cooling switch on rear of the cooler is ON.
See page 8, Temperature Control.
Water cooler hot water is not hot enough.
Check that the heating switch on rear of the cooler is ON.
Cooling system turns on and off
frequently.
The room temperature is hotter than normal.
The temperature control is not set correctly.
The water cooler does not have the correct clearances from the
wall.
Water has bad taste, either at startup or
after time when the cooler needs a clean.
Should you experience a bad taste please refer to cleaning
instructions page 9. Your water dispenser has been cleaned and
sanitized before leaving the factory, but in case a taste problem
develops, fill the tank with hot water and mix in two
tablespoons of baking soda, leave overnight and rinse out with
Содержание AQUA Cold
Страница 1: ...Page 1 of 12 ...
Страница 12: ...Page 12 of 12 ...
