Aqua To Go AQUA Cold, Руководство пользователя

Страница: 7 / 12

Page 7 of 12
Note: Always keep in mind safe manual handling procedures when moving the unit. Never lift or carry your
cooler by its taps or with bottle installed. Such action may damage the taps and will void the product
warranty.
A WATER SAFE AREA
The purchaser (owner) acknowledges that water, like other liquids, can cause damage to surfaces and also
create slip hazards. Do not place the water cooler on flooring or near electrical or other items that may get
damaged by water. The purchaser takes full responsibility for placing the cooler in an appropriate position as
per the guidelines above. The purchaser also acknowledges that any failure to address drips, leaks or spills is
at their own risk.
LIFTING AND CARRYING YOUR WATER COOLER
Don’t lift or carry the cooler by its taps as this may cause them to break. Don’t carry your cooler with a bottle
fitted. Always carefully lift the cooler using your legs and not your back.
DON’T LET YOUR COOLER RUN DRY
Never have the rear power switch on without water in the tank.
PRE RINSE INSTRUCTIONS
Your water cooler has been pre-cleaned but the reservoir and water lines should be flushed with fresh tap or
spring water AFTER it has been left to stand upright for 15 minutes.

Keep the cooler unplugged from the power socket.

Gently twist the water intake spike anticlockwise and lift off the top cover.

Slowly pour into the water tank spring or fresh tap water until the water level is at least 5cm higher
than the internal plastic plate. Let water settle for about two minutes.

Press the grey and blue taps until water comes out from both.

Plug the cooler into the electrical outlet and ensure the rear power switch is on. Both the power and
cooling indicator lights on the front will light up at first.

Now unplug the dispenser from the electrical outlet. Proceed to drain the water from the taps, one at a
time, until no more water remains. To facilitate this procedure, use a large container/bucket.

To put top cover back on, place into the slots, hold the spike and gently twist clockwise. Lift spike
gently upwards to test that the top cover is now properly secured on the cooler.
Note: Your water dispenser has already been cleaned and sanitized, but in the unlikely case that there is a
slight taste issue, place two tablespoons of baking soda into a bucket of hot fresh tap water, fill the water tank
again, leave it over night, and then repeat the above pre rinse instructions.
FITTING AN AQUA TO GO PREMIUM SPRING WATER BOTTLE

Place your water cooler in an appropriate position.

Read instructions on the bottle label and cap. Use a clean cloth to wipe over the cap and shoulder of
the bottle.

Carefully lift the bottle using your legs and not your back.

Gently place and then lower the bottle onto the water intake spike and allow it to sit for 10 minutes.

Plug in the power cord. Ensure the cooling power switch at the rear of the cooler is on.

Press down on each tap to ensure water flows correctly. Grey for room temperature water, Blue tap
for cold water.

The Power LED light & Cooling LED light will initially be lit and when the cold water reaches its
optimal temperature (allow up to 60 minutes) the Cold LED light will be lit.

Store all spare bottles in a cool place, out of direct sunlight.

Now you are ready to use your water cooler – Enjoy!