Page 8
Translation of the original operating manual
Working under the implement is forbidden.
The implements must be checked regularly by the operator (before every use) for any fractures and
cracks, chafe marks, leaks, loose bolts and connections, vibrations, unusual sounds, and to ensure
they function correctly.
Safety glasses and hearing protection should be used.
During assembly, the operator must ensure that the requirements for the tractor in terms of the power,
axle loads and weight distribution as specified in the operating manual are met and that the connections
specified in the operating instructions are made correctly.
When mounting the implement, the operator must ensure that connections to the tractor hydraulic
system are clean and carefully connected.
When performing the work passes, the tractor's speed must maintained as specified in the operating
instructions. This can be between 4 and 12 km/h.
Additional lighting (e.g., flashlight) should be used for repair or maintenance work if necessary.
5.3 Mounted implements
Before mounting and dismounting implements on the three-point linkage, move the operating devices
into the position that excludes unintentional lifting or lowering!
For three-point mounting, the mounting categories of the tractor and the implement must match or be
adapted!
There is a risk of injury due to crushing and shearing points in the area of the three-point linkage!
Do not stand between the tractor and the implement when actuating the external controls for the three-
point mounting!
When the implement is in transport position, always ensure that the tractor three-point linkage is
sufficiently locked to the sides!
When driving on roads with the implement lifted, the operating lever must be locked against lowering!
When mounting the harrow, the operator must ensure that there is a metallic connection made to the
tractor.
The operator must ensure that no one is in the vicinity of the harrow when it or its components are
being moved by the tractor's hydraulic system. The driver must perform a visual inspection!
5.4 Hydraulic system
Inspect the hydraulic hose lines at regular intervals and replace in case of damage or wear! The
replacement lines must comply with the technical requirements of the implement manufacturer!
The hydraulic system is under high pressure!
When connecting hydraulic cylinders and motors, the specified connection of the hydraulic hoses must
be observed!
When connecting the hydraulic hoses to the tractor hydraulic system, make sure that the hydraulic
system on the tractor and implement side is unpressurised!
For hydraulic function connections between the tractor and the implement, coupling sleeves and
connectors should be marked to rule out operating errors! If the connections are interchanged, the
function will be inverted (e.g. lifting/lowering)!
– Danger of accident!
Due to the risk of injury, use suitable tools when searching for leaks!
Liquids escaping under high pressure (hydraulic oil) can penetrate skin and cause serious injuries!
Consult a doctor immediately in case of injury! (Risk of infection!)
Before working on the hydraulic system, park the implement, depressurize the system and switch off
the motor!
5.5 Maintenance
Maintenance, repair, and cleaning work as well as the elimination of malfunctions should always be
performed when the drive is switched off and the motor is at a standstill!
– Remove the ignition key!
