APV MDC, Перевод оригинального руководства по эксплуатации

Страница: 30 / 52

30
Quality for Professionals
Operation on the field
When you start seeding, proceed as follows:
•
Start your towing vehicle.
•
Switch on the control box using the "On/Off" button.
•
MDP/MDS: start the fan / spreading plate using the "Fan / Spreading plate"
button.
•
MDG/MDP/MDS/MDC: to start the seed delivery, now press the "Seeding shaft"
button to start the gear motor.
NOTE: the next point is not applicable if you are working with a lifting unit sensor (7-
pin plug, tractor linkage sensor).
•
When you are turning at the headlands, you only have to press the "Seeding
shaft"
button. The green LED is turned off. To start again, press the "Seeding
shaft" button.
•
When the work is finished, first switch off the seeding shaft, then the blower
fan/spreading plate, and finally the entire control box with the "On/Off" button.
When operating the MDP on the field, the following points must be observed:
•
The blower fan should always be switched on during field operation
•
Verify the required spread rate
•
Check that the width division (distance) of the baffle plates
•
Check the height of the baffle plates: Distance from the ground approx. 40 cm
•
Angle of the baffle plates: Attachment plate for the baffle plates should be
mounted at approx. 90° (perpendicular) to the ground
•
The hoses should be routed slightly slanted down or horizontally on the
implement
•
The hopper cover must be tightly sealed
•
Check the placement depth of the seed
When operating the MDS on the field, the following points must be observed:
•
The spreading plate should always be switched on during field operation
•
Verify the required spread rate
•
Ensure a working height of at least 1.5 m (delivery height of the spreading plate)
When operating the MDG or MDC on the field, the following points must be
observed:
•
Verify the required spread rate
•
Check the placement depth of the spreading material