APV MDC, Перевод оригинального руководства по эксплуатации

Страница: 19 / 52

19
Quality for Professionals
Dismounting (changing) the seeding shaft
To dismount the seeding shaft, proceed as follows:
NOTE: when changing the seeding shaft, ensure that the hopper is completely
empty.
After installing the seeding shaft, check the implement for smooth running.
•
Empty the hopper completely.
•
Remove the hood on the side for the drive rollers.
•
Using the socket wrench supplied on the cover, loosen the nut so that the cover
can be pulled off upwards.
•
Pull the round belt off of the drive rollers (Fig.: 24).
•
Screw off the locking nuts of the cover plate for the seeding shaft on the side
(Fig.: 25).
•
Now remove the entire seeding shaft along with the side cover plate (Fig.: 26).
•
Read the required equipment of the seeding shaft from the seeding table (Point
6.11).
•
Now the new seeding shaft can be installed in the implement.
•
Install the disassembled parts again in the reverse sequence.
Fig.: 22
Fig.: 23 Fig.: 24