APV GW 250 M1, Руководство по эксплуатации

Страница: 12 / 24

12
7.3 SETTINGS AND WORKING WITH THE IMPLEMENT
Before beginning operation, the following must be performed:

Check bolted connections for firm seating

Relubricate the bearing

Check the mechanical integrity of all components
The recommended working speed is max. 8 km/h. On stony soils, a lower speed should be selected;
otherwise, the roller rings can break. The maximum transport speed is 25 km/h.
8 MAINTENANCE AND CARE
8.1 GENERAL MAINTENANCE INSTRUCTIONS
To maintain the implement in good condition even after a long service life, the following instructions must
be observed:

In Point 5, you will find some basic safety regulations for maintenance work.

Original parts and accessories are designed especially for the machines or implements.

Please note that spare parts and accessories not supplied by us have also not been tested and
approved by us.

The installation or use of such products can therefore possibly negatively change or impede the
constructional properties of your implement. The manufacturer rules out any liability for damages
resulting from the use of non-original parts and accessories.

The manufacturer is not liable for any unauthorised modifications and the use of components and
auxiliary parts.

CAUTION! Liquids escaping under high pressure can penetrate the skin. For this reason, a
physician must be consulted immediately in case of accident!!!

After cleaning, lubricate all of the grease points and distribute the grease evenly in the bearing
points (e.g. perform a short test run).

Do not use a high pressure cleaner to clean bearing and hydraulic parts.

The paint can be damaged by cleaning with excessive pressure.

During the winter, the implement should be protected against rust with an environmentally-
friendly product.

Park the implement protected from weather conditions.
8.2 REGULAR MAINTENANCE INSTRUCTIONS

All bolted connections should be re-tightened at the latest after 3 operating hours and again after
20 hours, and then checked regularly (loose bolts can cause significant consequential damage,
which is not covered by the warranty).

The grease points on the joints and bearings must be lubricated regularly (approx. every 10
operating hours with universal grease).

For implements with fast coupler, the guide slots must also be lubricated.

The platform kit and its access ladder must be visually inspected on a regular basis.

The rubber for fastening the access ladder of the platform kit must be checked regularly for wear
and replaced if necessary. It should only be replaced by trained specialist personnel and with
original parts.
8.3 REPAIRS AND SERVICE
In case of failure or damage to the implement, please contact the manufacturer. The contact data can be
found in chapter 3.