APV GW 250 M1, Руководство по эксплуатации

Страница: 10 / 24

10
Labelling of the
lubrication points.
Label for the recess for
installing the 24-mm
pins.
6.2 HAZARD LABELS
Do not climb onto
rotating parts, use the
intended access
ladders!
7 OPERATING MANUAL
7.1 MOUNTING ON THE TRACTOR

The air pressure in the rear tractor tyres should be 0.8 bar during operation. If the tyres have a lower
load capacity, increase the pressure.

Under difficult operating conditions, additional wheel weights can be useful. Please also refer to the
operating manual from the tractor manufacturer.

The tractor should be equipped with sufficient ballast weight at the front to ensure the steering and
braking capacity. At least 20 % of the empty vehicle weight is required on the front axle.

The lifting links must be adjusted to the same height on the left and on the right.

Mount the implement on the 3-point linkage of the tractor. The lower link pins must be inserted in the
upper bushing and the lower link ball must be secured against lateral slipping by the two spacer
bushings (Figure 2). The spacer bushings can be found in the toolbox, on the right in the roller
frame.

Mount the top link so that it slants down towards the tractor during
operation. Also refer to the sticker on the implement (observe the
specification of the tractor manufacturer).

After coupling, the parking support (Figure 3) is stowed in the shaped
tube of the roller frame (Figure 4).

When the seeder is mounted, the rear parking support must also be
folded up (Figure 5).