APV GW 250 M1, Руководство по эксплуатации

Страница: 8 / 24

8

Cleaning is recommended as specified in the maintenance instructions. The procedure in in
maintenance instruction must be observed and protective equipment must be used.

Working under the implement is forbidden.

The implements must be checked regularly by the operator (before every use) for any fractures
and cracks, chafe marks, leaks, loose bolts and connections, vibrations, unusual sounds, and to
ensure they function correctly.

During assembly, the operator must ensure that the requirements for the tractor in terms of the
power, axle loads and weight distribution as specified in the operating manual are met and that
the connections specified in the operating instructions are made correctly.

When performing the work passes, the tractor's speed must maintained as specified in the
operating instructions. This can be between 6 and 15 km/h.

Additional lighting (e.g., flashlight) should be used for repair or maintenance work if necessary.

When implement parts are moving (e.g. during the folding or pre-tensioning procedure) it must be
ensured that there is no one standing in the danger zone of the implement
– there is a risk of
crushing.

When driving through low or narrow obstacles (e.g. power lines, underpasses, etc.), attention
must be paid to the height and width of the implement to avoid collisions.

In case of loss or breakage of implement parts, they must be immediately replaced with original
parts by trained specialist personnel.
5.3 MOUNTED IMPLEMENTS

Before mounting and dismounting implements on the three-point linkage, the operating devices
must be moved into the position that excludes unintentional lifting or lowering!

For three-point mounting, the mounting categories of the tractor and the implement must match
or be adapted!

There is a risk of injury due to crushing and shearing points in the area of the three-point linkage!

Do not stand between the tractor and the implement when actuating the external controls for the
three-point mounting!

When the implement is in transport position, always ensure that the tractor three-point linkage is
sufficiently locked to the sides!

When driving on roads with the implement lifted, the operating lever must be locked against
lowering!

When mounting the implement, the operator must ensure that there is a metallic connection
(ensured by the lower link) made to the tractor.

The operator must ensure that no one is standing in the vicinity of the implement when it or its
components are being moved by the tractor's hydraulic system. Visual check by the driver!

Mounting of any sort of accessories onto the implement must be performed according to
standards.
5.4 MAINTENANCE

Maintenance, repair, and cleaning work as well as the elimination of malfunctions should always
be performed when the drive is switched off and the motor is at a standstill (remove the ignition
key) and the implement is uncoupled from the towing vehicle!

The maintenance work itself may only be performed by trained specialist personnel and may
never be performed alone.

Extreme caution must be taken when changing defective components or tools. Replacing
components that cannot be removed with tools such as a screwdriver or wrench may only be
replaced by specialist personnel from an appropriately authorised company or by APV Customer
Service.

If repairs or maintenance are required on the implement that can only be performed in
conjunction with the towing vehicle, this work must be identified by a clearly visible information
sign "Caution: maintenance work".

Check the nuts and bolts regularly for tight fit and retighten if necessary!