SC 230
1.2 PED Function (or CH2)
Press P2 button until PROG LED starts flashing; do not release P2 and wait for the flashing to become faster. Release P2
button
Enable the remote control key to be saved that you want to assign to the PED control within 10 seconds. Saving is completed
when the PROG LED will flash for a longer time.
Repeat the operation for each remote control to save.
1.3 Deleting a single remote control
Press P2 button until PROG LED starts flashing; do not release P2 and wait for the flashing to become faster; do not release
P2 and wait for the flashing to become very fast. Release P2 button.
Enable the key of the remote control that you want to delete within 10 seconds. Delete operation is completed when the
PROG LED will flash for a longer time.
Repeat the operation for each remote control to delete.
1.4 Deleting all remote controls
Switch-on the equipment by pressing the P2 button until the PROG LED starts flashing; do not release the button and wait for
the flashing to stop. ALL remote controls are deleted when the PROG LED will flash for a longer time.
1.5 Module Channel MCH2 function
To enable dell'MCH2 command with the second radio control channel:
press the P2 button until the PROG LED starts blinking; not release P2 and
wait until the flash gets quicker; not release P2 and wait for the flashing
become even faster; Release the P2 button.
Continue with point 1.2 to learn the second channel of a TM4 associated all'MCH2
1.6 DATA OUTPUT MCH2
CN2 connector can be connected to the coupon MCH2.
This board provides two NC and NO contacts that are activated for 1 sec at the reception of a
pulse from a remote control button associated with MCH2
If no remote control has been associated with MCH2 contacts are activated for about 1 sec in
Following a SEQ command, PED, or OPEN.
2)
STROKE PROGRAMMING
During saving, beside saving the slowing down spaces and the pedestrian opening stroke, the equipment will detect any
supervised safety input PH1, PH2 or SAF.
Press the save button P1 for at least 3 seconds
The PROG LED starts flashing: Release P1 button
Enable SEQ pulse:
The gate closes at normal speed
The gate searches the limit switch in closed position and stops.
After about 1 sec:
The gate opens at normal speed
When you decide to start the slowing down stroke phase, enable
SEQ
:
the gate slows down
The gate reaches the limit switch in open position and stops
After about 1 sec:
The gate closes at normal speed
When you decide to start the slowing down stroke phase, enable
SEQ
:
the gate slows down
The gate reaches the limit switch in closed position and stops.
After about 1 sec:
The gate opens at normal speed
To fix the partial pedestrian opening, enable
SEQ:
the gate stops
After about 1 sec:
The gate closes until the limit switch in closed position is reached and stops. Wait for the PROG
LED to turn off.
During stroke programming phase, if the stop time (TR1 trimmer DELAY) is set to 0 seconds, the pedestrian control will set to
stop time of 1 second of TR2 DELAY which cannot be changed; while if strokes are learned with DELAY > than 1 second, the
TR1 trimmer DELAY also changes the pedestrian function stop time.
14
