68
use and maintenance
Pegaso 650 I.E.
INSTALLING THE REAR CASE
SUPPORTS
J
(supplied as
standard equipment in the
countries where required)
Carefully read 51 (MAINTENANCE).
T h e f o l l o w i n g p a r t s a r e s u p p l i e d
together with the rear case supports:
– two screws T.C.E.I. M8 x 20 (1);
– two screws T.C.E.I. M8 x 30 (2) with the
relevant washers (3);
– two screws T.C.E.I. M8 x 55 (4);
– two self-locking nuts (5);
– two spacers (6);
– two rear couplings (7).
NOTE
The operations marked with
Q
are
not necessary if the side bag supports are
installed.
[
Remove the side panels, see p. 65
(REMOVING THE RIGHT AND LEFT
SIDES).
d
Unscrew and remove the screw (A).
[
Unscrew and remove the screw (B)
and take the washer (C).
NOTE
Take the screw (A) and position it
in a safe place in order to be able to use it
agan if necessary; the screw (B) and the
washer (C) will be reused in the following
operations.
d
Position the rear coupling (7).
d
Insert the screw (B) with the relevant
washer (C) and screw it manually.
[
Position the spacer ring (6).
[
Position the case side support (8).
[
Insert the screws (1) (4) and screw
them manually.
[
Position the plate (9) on the two side
supports (8).
[
Insert one of the screws (2), with the
relevant washer (3).
[
Working on the lower side, position the
nut (5) and tighten it manually.
d
Tighten the screw (B), applying the
torque prescribed.
Screw (B) driving torque: 25 Nm (2.5
kgm).
[
Tighten the screws (1) (4) and the nut
(5), applying the torque prescribed.
Driving torque screws (1) (4) and nut
(5): 25 Nm (2.5 kgm).
[
Put back the side panels, see p. 65
(REMOVING THE RIGHT AND LEFT
SIDES).
u
Install the rear case, see p. 23 (REAR
C A S E
J
( s u p p l i e d a s s t a n d a r d
e qu i pm en t i n t h e c o u nt r ie s wh e r e
required)).
Check the wear of the coupling pin every
6000 km (3750 mi) or 12 months, and if
necessary have it changed by an
aprilia
Official Dealer.
