Operation Manual
NPRT 2200
5.5.
Power Sweep
To run a test, select the setup file you want from the drop down menu. The frequency range and
notch frequency will default to the selections made in the setup file but you may change them if
desired. Enter any desired header information and then press START.
If you simply want to view an existing file, press Cancel and use the File menu to open the file.
The header information is optional and is stored in the data file and printed on the reports. You
may enter this information on this screen before starting the test, or may add it later with the
Header Information screen described below.
As the test is running, the progress will be shown in terms of segments and steps and the
measurements will be displayed as they are obtained. At the same time, the graph will be drawn
on the window behind the Power Sweep dialog box.
When the test is complete, a File Save dialog will appear that uses the serial number as the
default file name.
Page 14
