24
ADJUSTING THE HEIGHT OF MAGNETS AND BRUSHES (FIGURE 20)
The correct height adjustment of the magnets is .25-.32” (6-8 mm) and is important for regulating airflow through the machine and creating a good
seal. The magnets should be set at the maximum height of .32” (8 mm) for very rough surfaces. For very smooth surfaces the magnets should be
set at the minimum height of .25” (6 mm).
1. Remove the front and side brushes from the machine.
2. Tip the machine up and
scrape the shot from the magnets using a putty knife or similar tool.
3.
Adjust the rear wheel bracket so the bottom of the magnets are .25-.32” (6-8 mm) above the floor.
4.
Adjust the washer stack height of the front caster so the bottom of the magnets are .25-.32” (6-8 mm) above the floor.
5.
Replace the front and side brushes flush with the floor.
6.
Rear brush height should be 0-.125” (0-3 mm) from the floor.
Operation
24
FIG. 20
WARNING:
BEFORE ADJUSTING THE MACHINE, ALWAYS DISCONNECT THE MACHINE FROM POWER TO PREVENT ACCIDENTAL
STARTUP.
WARNING:
DO NOT USE YOUR BARE HANDS TO REMOVE SHOT FROM MAGNETS. STAPLES, NAILS OR OTHER SHARP OBJECTS
THAT MAY HAVE BEEN PICKED UP DURING USE COULD CAUSE INJURY.
.32
.25
8.00
6.35
.125 MAX. REAR BRUSH
FLOOR
BOTTOM OF MAGNETS
ADJUST FRONT AND SIDE
BRUSHES TO FLOOR
402306_A95_RevH
Содержание A95
Страница 3: ...Table of Contents 3 Labels 48 Wiring Diagrams 49 Handle 49 Blast Motor 50 402306_A95_RevH ...
Страница 51: ......
