18
Operation
18
PREPARING FOR OPERATION
Complete the following before start-up:
• Ensure all protective covers are attached correctly.
• Check that all parts are assembled correctly.
• Check that all fasteners are tight.
• Check parts for damage and wear; replace if necessary.
• Make sure the hopper is free of debris and that the shot valve functions properly.
•
Check the level of shot in the hopper; fill if necessary.
• It is important to operate the dust collector on a separate circuit from the shot blaster. The shot blaster needs the full amp draw to operate
effectively.
• Check that the dust collector is connected correctly and all hose connections are tight.
• Empty dust collector container.
• Check that the magnet height is approximately .25-.32” (6-8 mm) from surface. See
Adjusting the Height of Magnets and Brushes
for the
adjustment procedure.
• Sweep surface for loose parts prior to operation. Ensure that machine can travel over all inequalities on the surface; small inequalities like
weld seams or floor joints are not an issue.
• Run magnetic sweep over surface to remove any metallic debris.
•
Preload the magnets—Place a small amount of shot on the floor in front of the machine and push the machine back and forth over the
shot until gone to create a seal.
Note:
Whenever the machine is not used for blasting, the shot valve must be closed.
402306_A95_RevH
Содержание A95
Страница 3: ...Table of Contents 3 Labels 48 Wiring Diagrams 49 Handle 49 Blast Motor 50 402306_A95_RevH ...
Страница 51: ......
