APAR AR911, Инструкция пользователя

Страница: 6 / 12

6
4. Installation of batteries in the compartment
View from the bottom of the device after the cover is opened
6. BUTTON FUNCTIONS
a) button functions in the set/measured value display mode (normal mode)
Button Description [and marking in the contents of the instructions]
[PWR] :
- switches the device on/off (press for more than 1 second)
[IN] or [OUT] :
- sets the operating mode: input - IN (measurement) or output - OUT (setting)
[CONF] :
- view of the type of sensor set
- input in the parameter configuration menu (after holding for more than 2 seconds)
If parameter 18:
PPro
=
on
(password protection is activated) enter the password (chapter
8)
[UP] or [DOWN] :
- increase or decrease of the set value of the output signal by a preset increment
(parameter 10:
StEP
, chapter 8 )
[SET] + [UP] :
- a stepwise (limit) change of the set value of the output signal - upper value of the
indication range (20 mA, 10 V, parameter 4:
rtoP
) or setting range reduction (8:
LiLo
)
[SET] + [DOWN] :
- a stepwise (limit) change of the set value of the output signal - lower value of the
indication range (0/4 mA, 0/2 V, parameter 3:
rtoP
) or setting range reduction (9:
LiHi
)
[BAT] :
- view of the battery voltage: 0% - low level, 100% - high level
[SET] + [ESC] :
- view of the current or voltage value expressed in [mA] and [V], respectively (depending
on the type of set signal - parameter 1:
StYP
), resolution of indications equal to 10 μA or
10 mV
[SET]
- starting/stopping the soft/start function (after holding time longer than 1.5 second). If
parameter 12:
riSE
and 13:
FALL
=
oFF
the function is inactive (chapter 9)
b) button functions in the parameter configuration menu (chapter 8)
Button Description
[SET]
- edits of the current parameter
- approves and saves the edited parameter value