AP Expert VT-110, Руководство пользователя

Страница: 28 / 84

Chapter 7: Basic Operations
to 0 day (Off). If minimum ventilation cycles are used in clean mode, the air inlet goes to its minimum posi-
tion; otherwise it closes fully .
1. Using the menu select arrow keys, navigate to Clean Mode .
2. Set the following parameters:
Setpoint Select what is the target room temperature while the controller operates in clean mode.
Status Select On to enable the clean mode.
Use Min.
Vent? Select Yes to enable the minimum ventilation cycles while the controller is in clean mode.
*Accessible if a variable fan output is used in minimum ventilation.
Detect Lo
Temp? Select Yes for the controller to monitor low temperature alarms during the clean mode *A
password is required to change this parameter.
Using Test Mode
The test mode is used to simulate temperature changes and to verify the controller performances. During
the test, the room temperature probe inputs are turned off, allowing the user to change the temperature
used by the controller to operate the stages. The controller operates as before using the new temperature
settings. When the room temperature is defined by the test mode, the controller bypasses the tempera-
ture probe inputs and uses the new value as a reference. The Test Mode is deactivated after 15 minutes
of inactivity.
1. Using the menu select arrow keys, navigate to Test Mode .
2. Set the following parameters:
Test Mode Select On to enable the test mode or select Off to disable it.
Temp
Set the simulated room temperature to the desired value.
28 890-00081 Expert VT-110