AP Expert VT-110 Скачать руководство пользователя страница 19

Страница: 19 / 84

Chapter 5: Getting Started

Number of variable
outputs

Enable the proper number of variable outputs (1 or 2 outputs)

Number of clock
outputs

Enable the proper number of clock outputs ( 0 to 2 clock outputs)

Number of clock
cycles

If clock outputs are enabled, select how many timer cycles are being used by each
output (0 to 24 cycles)

0-10V outputs

Select the number of 0-10V outputs in use (0 to 2 outputs). * If the 0-10V brooder
is enabled below, the second 0-10V output will automatically be used to control the
brooder heater

0-10V output signal

Select the signal used by each 0-10V output (0-10V or 10-0V)

0-10V output use

Select the function of each 0-10V output (Ventilation or heating)

Use inlet?

Select

Yes

to enable the air inlet

Use inlet with

Select

Pot

if the inlet opening is defined by a potentiometer or select

Time

to con-

trol it with a timer. *This parameter is accessible if the air inlet is enabled above

Use over opening

A supplementary stage can be defined in order to continue opening the air inlet
beyond the activation temperature of the last ventilation stage. This overopening
stage is used to direct the airflow more efficiently during periods of warm weather.
Select

Yes

to enable the inlet overopening function or select

to disable it. *This

parameter is accessible if the air inlet is enabled above

Move in 1 step

The air inlet can either reach its over-opening position instantaneously when the
room temperature reaches a certain point or it can reach its over-opening position
gradually as the room temperature departs from the start temperature of the last
fan stage. Select

Yes

to use the instant opening mode or select

to use the pro-

gressive opening mode. Note that either case, the inlet reaches its full over-open-
ing position at : On T° of the last fan stage + Over-Opening bandwidth *This
parameter is accessible if the over-opening function is enabled above

Use tunnel?

The controller can control one tunnel curtain output. Select “Yes” to enable this
output

Tunnel open as

The controller can either display the tunnel openings as time values (in seconds)
or as positions (in %). Select the desired display mode

Use brooder

Select

Yes

to enable a brooder heater

Follow setPt
(Brooder)

Select

Yes

if the operating temperatures of the brooder heater follow the same var-

iations as the main temperature set points or select

if they are set as absolute

values

Brooder mode

Select the type of output that is used to control the brooder heater: relay or 0-10V
output. If the brooder uses a 0-10V output, it must be connected to 0-10V output
#2; if it uses a relay, select the proper relay in the relay assignment menu

Use HI fire

Select

Yes

to activate the brooder Hi fire option. This function allows activation of

additional brooder outputs

Use interlock?

Select

Yes

if you want the tunnel curtain to close while the heater stages or the

brooder heater is on

Use cooling?

The controller can control one cooling output. Select