Anyload 805BS Series, Руководство пользователя

Страница: 48 / 51

- 46 -
(2) Press until display shows “F 7” (see Fig. 9-1). Press to go to F7 Menu.
Display shows “F 7.1”. Press twice until display shows “F 7.3”.
(3) When indicator shows “F 7.3”, press again, display shows the current software
version “XX.XX”. Software version cannot be edited.
(4) Press to return to F7.3 Menu. Display shows “F 7.3”.
(5) Turn off the J1 switch to exit from the configuration mode and enter into weighing
mode.
9.2.2 Restore Factory Setup Parameters (Default Configuration Parameters)
（ 1 ） Set indicator to Configuration mode. Display shows “F 1”.
（
2
）
Press until display shows “F 7” (see Fig. 9-1). Press to show “F 7.1”.
Press until display shows “F 7.6”.
（
3
）
When display shows “F 7.6”, press . Display shows a 4 digit code “==0000”.
Edit it to “0711” according to Fig. 4-2. Press .
（
4
）
There are 2 possible outcomes:
z If input code is correct, display shows “Set ?” Then there are 2 options:
„
Press to restore parameters to factory setup and return to F7.6 Menu.
Display shows “F 7.6”.
„ Press , give up restoring factory setup and return to F7.6Menu. Display
shows “F 7.6”.
z If input code is incorrect, display shows “Err”. Then there are 2 options:
„ Press , display shows a 4 digit code “==0000”. Return to step (3) above
and re-enter the code.
„ Press , give up restoring factory setup and return to F7.6 Menu. Display
shows “F 7.6”.
（ 5 ） When indicator shows “F 7.6”, turn off the J1 switch to exit from the configuration
mode and enter into weighing mode.
9.3 Technical Specifications
A/D sampling rate 7.5 times/sec~960times/sec selectable
internal resolution 24bits
non-linearity ≤ 0.005%F.S
zero return ≤ 0.1 μ V/
℃
temperature effect ≤ 5ppm/
℃
full scale input signal 2~20mV