Anyload 805BS Series, Руководство пользователя

Страница: 38 / 51

- 36 -
(5) When the cursor at a certain digit position, press to edit. Display shows the
characters as shown in Appendix 9-5. “-” is shown for characters not available in
Appendix 9-5.
(6) When complete character editing, press to return to (4) above and to perform
editing other characters. When finish editing, press to return to F8.1 and
display shows “F8.1”.
(7) Press to go to F8.2 Menu and display shows “F8.2”. Refer to (3) to (6) for
format editing of NFMT.
(8) After finishing, turn off the J1 switch to exit from the configuration mode and enter
into weighing mode.
Note: When inputting characters, display shows characters as per Table 7-2. “-“ is
shown for unavailable characters.
7.3 Default Formating
（
1
）
Set indicator to Configuration mode and display shows “F1”.
（ 2 ） Press until display shows “F8” (see Fig. 7-1). Press to go to Print output
menu and display shows “F8.1”.
（
3
）
When display shows “F8.1”, press twice and display shows “F8.3”.
（
4
）
When display shows “F8.3”, press to show “Set?”. There are 2 options then:
z Press to change GFMT and NFMT format characters to default value in
Table 7-2, and then return to F8 Menu. Display shows “F8”.
z Press to give up restored default format operation and to return to F8 Menu.
Display shows “F8”
（ 5 ） Turn off the J1 switch to exit from the configuration mode and enter into weighing
mode.
7.4 Print Consecutive Number
Set print consecutive number in Print mode. F7.1 Menu (CONSNU) is the current
consecutive number. The consecutive number value is increased by 1 following each print
operation. When start up indicator, F7.2 is assigned as the initial consecutive number. F7.2
is used to set the initial consecutive number. Refer to F7.1 Menu and F7.2 Menu for details.