Antunes roundup MSS-200, Руководство пользователя

Страница: 6 / 20

MSS-200 MINI SPATULA STEAMER
6
P/N 1010903 Rev. A 09/05
1
1
1
2
3
4 5 6 7
8
9
0
2
3
4
5 6
7
8
9
0
2
3
4
5 6
7
8
9
0
SHOT
TEMP
CYCLE
SOL
HTR
1 1 1
2
34
5
6
7 8 9
0
2
34
5
6
7 8 9
0
2
34
5
6
7 8 9
0
SHOT TEMP CYCLE
POWER
STEAM
READY
� �
��
INSTALLATION
Unpacking
1. Remove unit and all packing materials from ship-
ping carton.
2. Open the carton. It should contain the following:
• MSS-200 Mini Spatula Steamer
• Water Pressure Regulator Kit
• Owner’s Manual
NOTE: If any parts are missing or damaged, con-
tact A.J. Antunes & Co. at 1-800-253-2991 or 1-630-
784-1000.
3. Remove all packing materials and protective cov-
erings from the unit.
4. Remove the Spatula, Top Cover, and Diffuser
and wipe them with a clean towel dampened with
sanitizer. Allow them to air dry.
5. Wipe all surfaces of the unit with a clean towel
dampened with sanitizer and allow to air dry.
6. Re-install all removed parts and verify that all
parts are present.
Equipment Setup
GENERAL
The MSS-200 Mini Spatula Steamer is designed to
heat products using steam. Products are placed on
the spatula, which is then inserted into the unit. When
the Steam button is pressed, a shot of steam heats the
product evenly.
MINI SPATULA STEAMER SETUP
When placing the Mini Spatula Steamer (Figure 1) into
service, pay attention to the following guidelines:
• Do not block or cover any openings on the units.
• Do not immerse cords or plugs in water.
• Keep cords away from heated surfaces.
• Do not allow cords to hang over edge of table or
counter.
3. Connect the outlet hose/fitting from the Dual
Water Regulator Kit to the Water Inlet Connection
at the rear of the unit (Figure 2).
4. Plug the power cord into the appropriate outlet.
5. Verify that the Rotary Switches on the back of the
unit (Figure 2) are pre-set to:
• Temp Rotor Switch - 0
• Cycle Rotor Switch - 0
• Shot Rotor Switch - 9
Figure 1. MSS-200 Mini Spatula Steamer
Ready
Light
Diffuser
Ring
Steam
Generator
Figure 2. MSS-200 Mini Spatula
Steamer (Back View)
Spatula
Steam
Button
Power
Switch
Top
Cover
Power
Cord
Water Inlet
Connection
Green
Solenoid
Led
Yellow
Heater
Led
Temp, Cycle,
and Shot Rotary
Switches as shown