MSS-200 MINI SPATULA STEAMER
10
P/N 1010903 Rev. A 09/05
OPERATION
Operating Instructions
1. Turn the Rocker Switch (power On/Off) to ON.
2. Allow the unit to preheat for a few minutes. The
yellow HTR (heater) LED, located on the back
of the unit, will illuminate during the time that the
heading element is heating up. When the unit is
ready for operation, the blue Ready light on the
front of the unit will turn on and remain lit.
NOTE: Do NOT press the Steam button or use the
steamer until it has warmed up and the Blue Ready
LED is ON.
3. Remove the Spatula and evenly distribute the
product onto the Spatula.
4. Insert the spatula into the steamer and press and
release the Steam button ONCE (Figure 1). The
Mini Spatula Steamer will initiate a shot of steam.
4. The Blue LED will turn off during the steam cycle.
5. When the blue LED turns on, remove the Spatula
from the unit and then remove the product from
the Spatula.
6. The unit is ready for another cycle.
Rotary Switch Settings
At the back of the MSS-200 unit are three Rotary
Switches: Temp, Cycle, and Shot (Figure 8).
• Temp Rotary Switch: Sets the operating tem-
perature of the unit.
• Cycle Rotary Switch: Sets the length of a steam
cycle in seconds.
• Shot Rotary Switch: Sets the amount of water
volume used in each cycle of operation. The
standard settings and other possible settings
are listed in Table 1.
Setting Temperature in
Fahrenheit
Cycle time
in seconds
Shot time
in secnds
0
375*
10.0*
1.0
9
370
9.0
0.9*
8
365
8.0
0.8
7
360
7.0
0.7
6
355
6.0
0.6
5
350
5.0
0.5
4
345
4.0
0.4
3
340
3.0
0.3
2
355
2.0
0.2
1
330
1.0
0.1
* These are the Standard Settings for the MSS-200.
1
1
1
2
34
5
6
7 8 9
0
2
34
5
6
7 8 9
0
2
34
5
6
7 8 9
0
SHOT
TEMP CYCLE
SOL HTR
Figure 8. Rotary Switch Settings.
Table 1. Rotary Switch Setting Table.
