26
5. Troubleshooting SYMPTOM:
VDSL LNK LED does not light after wire is connected to the
VDSL port.
CHECKPOINT:
1. Verify the length of the wire connected between two units
of EVC-3001 is not more than 2.0km and EVC-3010 is not
more than 3.0km. Please also try to adjust the DIP switch of
EVC-3001 / EVC-3010 to other SNR mode.
2. Please note you must use one EVC-3001 / EVC-3010 with CO
mode and the other EVC-3001 / EVC-3010 with CPE mode,
connect to each other to make it work.
SYMPTOM:
TP LED does not light after cable is connected to the port.
CHECKPOINT:
1. Verify the Cat.5, 5e or 6 cables with RJ-45 connector to
connect to the port.
2. If the device (like LAN card) supports to Auto-Negotiation,
please try to modify at a fixed speed of the device by manu-
ally.
3. Check the converter and the connected device’s power are ON
or OFF.
4. Check the port’s cable is firmly seated in its connectors in the
switch and in the associated device.
5. Check the connecting cable is good.
6. Check the power adapters are functional, including the
connecting device.