23
3.3 Connecting EVC-3010
3.3.1 Connecting Standalone IP Device
Refer to the following procedures to setup the EVC-3010 to a
standalone PC.
1. Set the EVC-3010 to be CO or CPE mode from the DIP switch
at the rear panel.
2. Power on the EVC-3010 by connecting its power source.
3. Power LED will illuminate.
4. Connect coaxial cable from another VDSL device to VDSL BNC
port of the EVC-3010.
5. LNK LED will blink for illuminating.
6. Connect Ethernet port to Ethernet device via regular Cat. 5,
5e or 6 cables.
EVC-3010
VDSL
BNC
IP Camera
RG58 Jack
RJ-45
Cat.5 Twisted Pair Cable
RG58 / RG6
TP
VDSL2
100Base-TX UTP
VDSL2 Coaxial Cable
VDSL2
Figure 3-5:
Connecting Standalone IP Device