Anolis ArcPower 72/K2, Руководство пользователя

Страница: 12 / 20

1
8.Control board
The control panel situated on the top cover of the ArcPower 7/K allows DMX addressing,calling Built-in pro-
grams and setting the fixture behaviour
Control elements:
[ENTER] button- enters menu,confirms adjusted values and leaves menu.
, [UP] button and[DOWN] button- moves between menu items on the the same level, sets values.
In order to leave the menu without saving value,press [UP] and [DOWN ] at the same time.
After switching on the ArcPower 7/K ,the display shows the initial DMX address:
Use [UP],[DOWN] to browse through the menu. To select a function or submenu,press [ENTER].
8.1 Addressing the ArcPower 72/K2
The fixture can be operated in the two modes: DMX mode -fixture is controlled via DMX 512 by an external
DMX controller
Stand-alone mode - fixture uses Built-in programs and is
able to control other fixtures in the master/slave chain.
See the chapter "Stand-alone mode" for detail description.
For DMX mode, it is important to define the starting DMX address from which the ArcPower 72/K2 will respond
to the DMX controller
Setting the DMX start channel for DMX operating:
1.
Connect ArcPower 7/K to the mains.
2.
Browse through the menu by pressing the [UP] and [DOWN] buttons until the display shows current addres
"001"
.Confirm by pressing [ENTER] button and
"001"
will start to flash frequently.
3.
Use the [UP] and [Down] buttons to select the desired address.
4. Confirm by pressing [ENTER].
After having addressed ArcPower 7/K , you may now start operating ArcPower 7/K via your DMX control-
ler.
8.2 Program running
By entering this menu a complete overview of all programs is offered,from which the program to be run can be
selected by pressing [ENTER].Selected program runs in a loop.The fixture includes 6 built-in programs (P.01-
P.6) and 3 free editable programs (E.P.1-E.P.3),each up to 30 steps.
If item " AUt " is On,the fixture in DMX mode will remember last running program and this program will run after
switching on the fixture.
Each program step has a fade time - the time during which effects go to the current step and a Standing time-
-the time,during which effects last in the current step.