Anita GZ-539-407, Руководство пользователя

Страница: 27 / 39

ANITA ©
Serie GZ-539
27
11. ADJUSTMENT
11.1. Notes on adjustment
All following adjustments are based on a fully assembled machine and may only be
carried out by expert staff trained for this purpose. Machine covers which have to be
removed and replaced to carry out checks and adjustments, are not mentioned in the text.
The order of the following chapters corresponds to the most logical work sequence
for machines which have to be completely adjusted. If only specific individual work steps
are carried out, both the preceding and following chapters must be observed. Screws, nuts
indicated in brackets ( ) are fastening for machine parts, which must be loosened before
adjustment and tighten again afterwards.
11.2. Tools, gauges and other accessories
•
1 set of screwdrivers with blad widths from 2 to 10 mm.
•
1 set of wrenches with jaw widths from 7 to 14 mm.
•
1 set of Allen keys from 1.5 to 6 mm.
•
1 metal ruler.
•
Threads and test material.
11.3. Abbreviation
t.d.c = top dead centre
b.d.c = bottom dead centre
Please observe all notes in Chapter 2 Safety of the instruction
manual! The particular care must be taken to see that all protective
devices are refitted properly after adjustment, see Chapter 2.6.
Danger of warnings of the instruction manual!
If not otherwise stated, the machine must be disconnected
from electricity supply.
Danger of injury when the machine is switched on
accidentally!