Anest Iwata MSU B193, Руководство по эксплуатации и обслуживанию, Страница: 27 / 48

- Position the limit switch (42) and the limit switch cover
plate (44) by fastening them onto the hub with the screws
(43).
- Position the suction pipe assembly (7) and tighten the
nuts (6).
- Position the delivery pipe assembly (1) and tighten the
nuts (2a) and (2b).
IMPORTANT
To install the delivery pipe assembly (1) and the suction
pipe assembly (7), please read paragraphs 6.8 and 6.10.
6.7 Hydraulic motor maintenence
Paragraphs 6.5 and 6.6 describe the procedures required for replacing components of the
motor group.
WARNING:
- If maintenance operations are required, follow the instructions in paragraphs 6.5 and 6.6
carefully.
- It is recommended to remove the bellows only if it must be replaced
6.8 Delivery pipe installation procedure
- Position the filter assembly (F) onto the plate (H) near the
fastening slots.
- Partly tighten the screw (I) to fasten the filter.
IMPORTANT:
The filter must not be blocked by the plate but must be
free to move in the two directions shown in the picture.
27
FIGURA A