Anest Iwata MSU-323 C, Инструкция по эксплуатации и обслуживанию, Страница: 17 / 32

17
PRECAUTIONS
a) Use Multi Spray guns only.
b) When the paint level inside the tank decreases, the pump might suck some air. Increase the
level of paint.
b) Do not drag the pump by pulling it by the hoses.
d) Do not spray towards the eyes or towards other people.
CAUTIONS: EMERGENCY STOP
Whenever the pump must be stopped due to one of the following reasons:
a) The material never stops coming out of the gun
b) Fluid discharge through the connectors or the damaged hose.
THEN, close the BALL VALVE (pos. 3-8 on page 27 and 28).
WARNING
a) When assembling or removing the gun nozzle, always bock the trigger by means of the safety
catch.
b) Never exceed the maximum working pressure (6.8 bar).
c) Always use an ANEST IWATA Multi Spray gun, which is provided with various safety devices.
d) During functioning, never touch the moving parts. Before carrying out any maintenance operation
disconnect the air supply and discharge the residual pressure.
6.6 DAILY INTERRUPTIONS
1. Upon suspending the use of the pump:
- It is not necessary to disconnect the air supply if the interruption is short.
- If the interruption is long, turn the ball valve (pos. 3-8 on page 27 and 28), discharge the air
from the circuit and open the recirculation valve (pos. C in pic. 2 on page 14) to release the residual
fluid pressure.
2. When the pump is stopped at the end of the working day:
- Clean the fluid passages.
- Remove the dip tube filter, the filter inside the delivery paint filter and the gun filter, and clean them.