Anest Iwata MSU-111N, Инструкция по эксплуатации

Страница: 13 / 40

- 11 -
Ű 4. Setup
4-3. Checking operation
WARNING
1. Never touch moving parts.
IMPORTANT
1. Do not keep pump idling for extended periods of time. Prolonged idle operation may cause premature
pump failure.
Refer to Fig.1 on page 8 or Fig.2 on page 9 to find reference letters.
1. Check Fluid Filter Set (I) if installed, suction filter installed on Suction Hose Set (E) and filter set installed on
spray gun. If they are clogged, clean or replace.
2. Close Air Regulators (C and F) fully.
3. Open Circulation Valve (G).
4. Set Emergency Valve (D) to “ Operating ” position.
5. Turn on the air supply to the unit.
6. Remove
Suction Hose Set (E) from the pump fluid inlet and adjust Air Regulator (C) to 22 - 73psi (0.15 -
0.5MPa, 1.5 - 5bar) slowly.
7. After pump is running, cover fluid inlet fitting underneath the pump with your palm and feel for suction to make
sure that pump is working. If not, see 8. Trouble Shooting on page 16.
8. Set Emergency Valve (D) to “ Emergency Stop ” position to make sure that pump operation stops.
9. Close Air Regulators (C and F) fully.
10. Connect Suction Hose Set (E) and Circulation Tube (H). If they are clogged or damaged, clean or replace.