Anest Iwata MSU-111N, Инструкция по эксплуатации

Страница: 24 / 40

- 22 -
Ű 9. Disassembly and Assembly
9-2. Assembly
9-2-1. Air motor section
a) PP-7131N (13:1 pump)
IMPORTANT
1. Put general-purpose grease on the moving parts, o-rings and packings inside air cylinder. Do not put
grease on the parts of the seat block section.
2. Make sure that the interlock pieces are set on the slit of air motor rod.
3. Make sure that the switch block switches up when the air motor rod is at the end of the up stroke and
switches down when the air motor rod is at the end of the down stroke.
1. Place the rod guide onto the air motor rod.
2. Place the following parts on the air motor rod and
tighten the cap nut.
- O-ring
- Piston washer
-
Piston packing
3. Place the air motor rod into the air motor body and
tighten the rod guide onto the air motor body.
4. Tighten the air motor rod to the adaptor and
replace the split pin.
5. Tighten the air cylinder.