Anest Iwata E-M20 Series, Инструкция по эксплуатации

Страница: 57 / 70

- 15 -
２） Inspect output of electrostatic controller
（
E-SC12BH
）
CAUTION
(1) Never contact No.5 terminal
（
pin
）
, connector case or other terminal with test bar of tester. If done, it
can damage circuit since excessive current flows in electrostatic controller.
(2)
Pay attention to the range of tester. If not, it can damage tester and electrostatic controller.
①
Measure output voltage between electrostatic controller connector No. 5 terminal and electrostatic
controller ground terminal
◎
Normal figure
＝
In the range of DC11.5
〜
12.5V
◎ Measuring condition ： Set voltage at -40kV(MAX), remove low voltage cable from electrostatic controller,
keep electric source of electrostatic controller ON and then measure use tester to measure voltage.
Normal figure DC 11.5〜12.5V
EBC-12S7
Connect to ground
Tester
E-SC12BH