Anest Iwata E-M20 Series, Инструкция по эксплуатации

Страница: 51 / 70

- 9 -
４．３
Check grounding
Job − 1 Ground all conductive objects within 3 m from electrostatic hand gun.
WARNING
(１)
Ground all conductive objects within 3m from electrostatic gun to avoid electrostatic
electric accidents （ electric shock and fire ） .
Job
−２
Turn on electric source of electrostatic controller
（
E-SC12BH
：
option
）
or multi-gun control system
（
E-MC12
：
option
）
and check that ground failure does not display.
（
Regarding turning on electric
source and failure display, refer to instruction manual of electrostatic controller or multi-gun control
system
） .
４．４
Setting spray conditions
（１）
Air pressure
Adjust air regulator
（２）
Fluid output / pattern width
Adjust fluid output by fluid pressure adjustment and locked fluid adj. knob and adjust pattern width by pattern
adj. set.
（３）
Check spray distance
Set spray distance at about 200
〜
300mm in order to get proper electrostatic effect.
Hints about electrostatic painting
Bad penetration into recessed section
and paint buildup on protruded section
Too much bounce back
Spray pressure
Increase
Spray distance Closer
Pattern width Smaller
Voltage
Decrease
Spraying Spray recessed
section first
Spray pressure Increase
Spray distance
Closer
Pattern width Smaller
Voltage Decrease
Spraying Spray recessed
section first
Check grounding