Anest Iwata E-M20 Series, Инструкция по эксплуатации

Страница: 47 / 70

- 5 -
4. Connection and setting
４．１
Connection of electrostatic gun
Before connecting electrostatic gun, be sure to read and observe the below chart. In case of E-M25 series gun,
refer to
｢
standard connection example of (1)E-M25 series
｣
on page. Refer to
｢
standard connecting example
of (2) E-M20 series
｣
on page 8 for E-M20 series gun and then install the gun.
WARNING
(１)
Before connection, be sure to turn off primary side electric source, release primary side air
source and turn off all electric source switches. (refer to P.
④「
avoidance of wrong operation
」
)
(１) Be sure to check that all products are grounded. If not done, it can cause fire by spark
discharge through leakage or charge and bodily injury by electric shock.
( １ ) Be sure to use designated primary side electric source for electrostatic controller
（
E-SC12BH
：
option
）
or multi-gun control system
（
E-MC12
：
option
）
. Input of different voltage
other than designated one can cause damage to the product or fire （ refer to instruction
manual of electrostatic controller or multi-gun control system as for details
）
.
(２)
Max. air pressure of primary side air source must be less than 0.68MPa. If higher, it can
cause damage to the product or accident since the product is not for high pressure.
CAUTION
（１） Be sure to clean air filtered through air dryer, air filter （ 3 〜 5 μ m ） and oil mist separator(0.03 〜 0.01 μ m).
When using lubricator in air supply piping, take air from separate supply piping or filter through over
two-stage oil mist separators. Dirty air for painting can fail painting.
（２）
When using for the first time after purchase, spray thinner into the inside of fluid passage and remove
anti-rust oil. Remaining anti-rust oil can fail painting such as fish eyes.
（３）
Before connecting air hose to electrostatic gun, fully blow air. Dust in piping can fail painting.
（４） Before use, filter paint to remove dust or foreign matter from paint. If not, it can cause leak from seated
section and make initial fluid output unstable.
（５） Electrically connect electrostatic controller （ E-SC12BH ： option ） or multi-gun control system （ E-MC12BH ：
option
）
and other equipment in accordance with this instruction manual and instruction manuals of other
related products.
（６）
Bind low voltage cable, air hose and fluid hose so that there is no partial tension or bend. Refer to (4.2
｢ Precautions on installation and handling of low voltage cable ｣ (P.6)