Anderson Group
Double Stretcher – Operator’s Manual
17
4
Settings
The plastic film must set correctly in the cut and hold system so that it will function properly.
As it is the folding arm that determines the position that the film is placed to be cut correctly
the following settings will serve to adjust this component:
•
The height of the folding arm;
•
The angle of the stainless steel arm compared to the ground.
It is best if all of these adjustments are carried out before putting on the roll of plastic.
Warning!
When you are running the wrapper in manual
mode, it is possible that the folding arm may come
in contact with the receiving table of the wrapper.
To avoid collisions, completely raise the folding arm
before turning the table of the wrapper.
4.1
Adjustment for the height of the folding arm
To adjust the height of the folding arm so the film sets correctly on the plastic cut and hold,
you have to first drop the folding arm as low as it will go.
To adjust the height of the folding arm, proceed as follows:
1.
Turn off the computer to be able to manually control the double stretcher.
1.
Start the engine of the wrapper.
2.
By using the unloading lever (see Figure 4), lower the folding arm until the drop off
panel begins to rise. Stop the arm (release the lever) in this position.
NOTE :
The folding arm of the double stretcher is on the same
hydraulic circuit as the drop off panel and the dumping
tablep (unloading platform). When you activate the lever
for the drop off the arm of the double stretcher will lower
and push down on the plastic film. Then the drop off will
rise and the rotating table will dump the bale from the
wrapper.
