Displaying Stream Content
178
VG-Series Modero Touch Panels
If there is no signal displayed, return to the MAX-CSE UI pages and from the
Encoder Profiles page, confirm that the correct panel IP Address and target port
where entered into the
Streaming Source
field within the TPDesign4 project.
If this still doesn’t produce a displayed signal, cycle the
Play
/
Stop
buttons and
verify that both the encoding Status says
Streaming
(verifying that the process of
encoding is underway) and that the unit is detecting an incoming signal (shown by
the word
SYNC
appearing in the Video Sync section of the UI).
The most common error can result from a bad cable not being detected and therefore
no signal becomes available for the unit to encode. The encoding process can
continue on a MAX-CSE even without an actual signal being detected.
FIG. 136
Video Adjustment page (showing default values)
Incoming Video signal
Once done making your screen
adjustments, SAVE SETTINGS.
Содержание Modero NXT-1500VG
