As an example, enter the word
AMXPanel
using a 128-bit hex digit encryption. After
pressing
Done
, the on-screen Current Key field displays a long string of characters (separated
by colons) which represents the encryption key equivalent to the word AMXPanel.
This series of hex digits (26 hex digits for a 128-bit encryption key) should be entered as
the
Current Key
into both the WAP and onto other communicating Modero panels by
using the WEP Key dialog (FIG. 35).
9.
Write down this Current Key string value for later entry into your WAP’s
WEP Key
field (
typically
entered without colons
) and into other communicating panel’s
Current Key
field (FIG. 35).
10.
If you are entering a Current Key generated either by your target WAP or another Modero
panel
, within the
WEP Keys
section, touch the
Key #
button to launch the
WEP Key #
keyboard
(FIG. 35), enter the characters and press
Don
e when finished.
This Key value corresponds to the Default WEP Key number used on the Wireless Access
Point and selected in the Default Key field described in the previous step.
11.
The remaining
Current Key
and
Authentication
fields are greyed-out and cannot be altered by the
user.
12.
Verify the fields within the IP Settings section have been properly configured. Refer to
Step 1:
Configure the Panel’s Wireless IP Settings
section on page 33 for detailed information.
13.
Press the
Back
button to navigate to the Protected Setup page and press the on-screen
Reboot
button to both save any changes and restart the panel.
Remember that you will need to navigate to
the System Settings page and configure the connection to a target Master.
14.
After the panel restarts, return to the Wireless Settings page to verify the Link Quality and Signal
Strength:
The descriptions are:
None
,
Poor
,
Fair
,
Good
,
Very Good
, and
Excellent
.
Refer to the NXA-WAP200G Instruction Manual for more detailed setup and configuration procedures.
FIG. 35
If your target Wireless Access Point does not support passphrase key generation and
has previously been setup with a manually entered WEP KEY, you must manually
enter that same WEP key on your panel.
The signal strength field provides some descriptive text regarding the strength of the
connection to a Wireless Access Point. If there is no signal or no IP Address
displayed; configuration of your network could be required.
