6.
To complete the upgrade process, either upgrade the remaining wireless card (Step 3) or close and
re-secure the enclosure using the procedures in
Step 3: Close and Resecure the NXD Panel
Enclosure
section on page 11.
1.
Gently place the outer housing back onto the panel and align the four pan-head Housing Screws
holes along the edges of the outer housing.
2.
Insert and secure the four pan-head Housing Screws back into their pre-drilled holes by using a
grounded Phillips-head screwdriver.
3.
Slip the connector overlay back into the connector opening by inserting the top of the overlay into
the connector opening in an upwards direction.
4.
Align the connectors to their respective locations and secure the overlay by pushing it towards the
connectors until the overlay securely snaps back into the overlay release latches.
5.
Re-install the faceplate back onto the panel. Refer to the
Installing the Button Trim Ring
section on
page 14 for more detailed faceplate installation information.
FIG. 6
Card removal
grooves
Insert with arrow
facing towards the pins
On-board Compact
Flash connector (with pins)
Connector opening
Any new internal card upgrade is detected by the panel only after power is cycled.
