Terminal (Program Port/Telnet) Commands
88
NetLinx Integrated Controllers (Firmware v4)- WebConsole & Programming Guide
Terminal Commands (Cont.)
Command
Description
DEVICE STATUS <D:P:S>
Displays a list of all active (on) channels for the specified D:P:S. If you enter
DEVICE STATUS
without the D:P:S variable, the Master displays ports, channels, and version information.
DIPSWITCH
Displays the current state of the Master's hardware dip switches.
DISK FREE
Displays the total bytes of free space available on the Master.
Example:
>DISK FREE
The disk has 2441216 bytes of free space.
DNS LIST <D:P:S>
Displays the DNS configuration of a specific device including:
• Domain suffix·
• Configured DNS IP Information
Example:
>DNS LIST [0:1:0]
Domain suffix:amx.com
The following DNS IPs are configured
Entry 1-192.168.20.5
Entry 2-12.18.110.8
Entry 3-12.18.110.7
ECHO ON|OFF
Enables/Disables echo (display) of typed characters.
GET DEVICE HOLDOFF
Displays the state of the Master’s device holdoff setting.
Note: This command reveals the state of the device holdoff set using the DEVICE HOLDOFF ON|OFF
command (see page 87).
Example:
>GET DEVICE HOLDOFF
Device Holdoff is off.
GET DUET MEMORY
Display the amount of memory allocated for Duet Java pool. This is the current Java memory heap
size as measured in Megabytes. An example is a value of 5 = 5 MB.
GET ETHERNET MODE
Displays the current LAN configuration setting. Settings are either "auto" in which the LAN driver
will discover it's settings based on the network it is connected to OR <speed> and <duplex> where
speed is either 10 or 100 and duplex is either full or half.
Example:
>GET ETHERNET MODE
Ethernet mode is auto.
Note: See SET ETHERNET MODE.
GET IP <D:P:S>
Displays the IP configuration of a device. If you enter GET IP without the D:P:S variable, the Master
displays its D:P:S, Host Name, Type (
DHCP
or
Static
), IP Address, Subnet Mask, Gateway IP, and MAC
Address.
Example:
>GET IP [0:1:50]
IP Settings for 0:1:50
HostName MLK-INSTRUCTOR
Type DHCP
IP Address 192.168.21.101
Subnet Mask 255.255.255.0
Gateway IP 192.168.21.2
MAC Address 00:60:9f:90:0d:39
HELP SECURITY
Displays security related commands.
Note: This command is only available to Program Port terminal sessions. It is not available to Telnet
sessions (see the Overview
).
Example:
>HELP SECURITY
>logout Logout and close secure session
>setup security Access the security setup menus
ICSPMON ENABLED|DISABLED
[PORT]
Enables or disables ICSP monitoring out the specified IP port. By enabling icspmon on an IP port,
an external application could connect to that port and "listen" on the ICSP traffic.
IP STATUS
Provides information about the current NetLinx IP Connections.
Example:
>IP STATUS
NetLinx IP Connections
No active IP connections